![]() ![]() ![]() WET AND DRY TRIMMING MODES USING THE CUTTING BLADE Properly adjusting the rotation and separation will reduce batch times. Again, this is something you will want to adjust based on whether you are Trimming wet or dry product, as well as for different strains and densities. Typically, we recommend that you run the fingers in the forward direction, and at higher speeds. ![]() Wet Buds, and specific dry strains, require more agitation than others, and thus, require the fingers to be run at higher speeds. The goal is to adjust the fingers, and the airflow, so that the product is being moved by the air, then rolled and separated by the fingers. Slowing down the fingers will minimize agitation on delicate product, while running the fingers on higher speeds, or in reverse – which is the opposite direction of the airflow, can create more agitation, and quicker Trim cycles. Both the direction and speed can be controlled. The rotating soft silicone fingers are used to help separate and roll the product along the grate. Properly adjusting the airflow and suction eliminates excessive handling and friction. The air flow is considered properly adjusted when it predominately moves the product around the grate, while still allowing the silicone fingers to separate and roll the product. Adjust the airflow controller according to the strain, size, and density of the wet or dried product. The airflow controller is used to prop open the back inner lid, allowing you to fine tune the amount of airflow and suction. This allows you to create stronger airflow for the movement of wet or heavier product or less airflow, and more suction, for slowing down the movement of dry or delicate product. With one or both inner lids open, the suction will increase, and the airflow will decrease. The two inner lids can be opened or closed, to increase or decrease air flow and suction. Adjusting the airflow properly is key to achieving an efficient Trim cycle and eliminating potential damage. The suction and airflow created by the fan blade is controlled using the airflow controller and by the two inner lids on the top of the machine. Lastly, it agitates the clipped leaf in the filtration bags, helping to remove the trichomes as they are filtered through the bags. Second, it creates a controllable vortex of air that assists in moving and dispersing the product along the grate as it’s Trimmed. First, the fan blade creates suction to pull the leaf down through the grate and into the filtration bags. The Bud Trimmer has a fan blade directly below the cutting blade that does several things. 120 VAC 60 HZ Single Phase 10 Amps 1200 Watts.Gear Motor Fuse Holder AC to DC 5V Power Supply 4 Channel DC 5V Relay Module Touch Screen Motor Speed Controller Control Box Microcontroller 9′ power chord Meanwell power supply Main Motor Capacitor.Aluminum 6061 – FG Stainless Steel – FG Silicone – FG Nylon – FG.(Wet trimming in wet weight, dry trimming in dry weight) Production (single operator): 30-50 lbs./hr.Assembled Dimensions: 32″L x 29″W x 42″H.1 person can easily operate 4 Bud Trimmers.Reduces touch-up due to batch time control.The Bud Trimmer is not only quiet, lightweight, and filters your Trim, it has the following unique adjustable controls, that make it second to none: Bud Movement, rotation and separation, Wet and Dry Trimming, batch time, and Trim Collection The key to the Bud Trimmers superiority, is that it allows the user to adjust the way in which it Trims, for wet and dry product, as well as different strains, sizes, and growing methods. It is for the commercial cultivator who requires efficiency but refuses to compromise the quality and integrity of their product. The Satellite is a wet and dry trimmer that offers the most control of any commercial trimmer on the market. The Bud Trimmer removes unwanted leaves from cannabis and hemp Buds. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |